I got a brand new laser, but it doesn't seem to work. What shall I do?

Before calling your vendor our our service line, please check the following points:

- do you use the right operation voltage?

- is the environmental temperature not below 10°C?

- is the interlock connector plugged in (if there is a interlock connector, of course)?

- is the key switch turned to "on"?

- if there is a mechanical shutter: is it moved aside?

- doese the laser only not work in one operation mode (sound, auto, ILDA - as far as the options are available for your unit)?

- if operated in ILDA mode: Do you operate your software properly? (Interface connected, cable properly attached, laser output activated in software, right interface selected for output in software?)

- if operated in ILDA mode: Do you try to project a single beam or a very small pattern? Probably the scan fail safety blocks that (it only does if switched to full block mode! This is not the standard option.)... please try a larger pattern.